In september I'll change to optical fiber, so I'll focus on setup the ONT properly.PfSense is a free and open-source operating system for routers and firewalls, and is typically configured as DHCP server, DNS server, WiFi access point, VPN server, all running on the same hardware device.
I'm going to keep this setup and start to play with pfsense. I don't undrestand the line 2, and 3-4 are private IPs?. Tracert 1 <1 ms <1 ms <1 ms pfSense.MyDomain Ģ 13 ms 12 ms 12 ms ħ 32 ms 32 ms 32 ms .net Ĩ 32 ms 32 ms 32 ms .net ipv4 address is my pulbic IP, but Gateway ipv4?Ĭould you help me to understand this output of tracert command? In Status > Interfaces, I see: IPv4 address 47.X.X.X and Gateway IPv4 87.X.X.X. But I can't access to the ISP router - 192.168.1.1 (even connecting directly pc-isp router), why? is it normal?. Pfsense is working well (I configured ppoe user and password), with connectivity and internet. In wan services: check "Bridge PPPoE Frames Between WAN and Local Ports" and uncheck NAT and Firewall. My ISP router in "transparent"? I'm completely lost in this issue.Īctivate in the options menu the "bridge mode" if it is available, then the ISP router isĪcting as a ordinary modem, would be the best for pfSense and VPN from the outside!īecause if you have coupled two routers you had build up a router cascade with double NAT.Ģ. set up the IPS router to the bridge modus and then use this device as a pure modem and set up DHCPīut my ISP router is working normal (wifi, lan, etc).
enable DHCP at the ISP router and set up a static IP address outside of the DHCP range to the WAN port of the pfSense firewall.disable DHCP on the ISP router and set up a static IP address on the WAN interface of the pfSense.Three things would be matching at this point and situation Why DHCP? Set up the WAN IP static (fix) and deactivate DHCP at the ISP router.Įverything is working fine, I can access to ISP router using 192.168.1.1, pfsense with 192.168.2.1, I have internet…
0 kommentar(er)
